How to Make Your Own Dog Mask – The Fundamentals

In this article we’re going to look at how to make your own dog mask. We’ll cover the basics and then go on to take a look at a number of the more advanced tips and techniques which you can use.

For those who have a dog that likes to bark, and particularly if your dog loves to play in the backyard and other areas of the house, you need to get them some special dog protection.

Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the setup that will look a little scary at first, but it’s actually quite straightforward. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can not just cut a rectangular shape from the cardboard, so you’ll need to cut around the edge of the mask so that you get something that looks like a cone. The most important thing here is to be realistic with what type of paper plate which you’re using.

Then you’ll have to wrap the cardboard around the edges of the paper plate, making certain there is a good seal between the two pieces so you can ensure that nothing will leak once you place the mask on. Make sure that the edges are cut so that the edges are not sharp, as this can damage the edges of the mask.

Glue it on! The next step involves using some paint. You should spray the paint dog filter mask over the cardboard, making sure that it runs smoothly and evenly across the whole mask. You will want to start with one side of the mask , so you can work your way round it before moving onto the other side. The paint needs to be slightly thicker than the cardboard, and it’s best that you leave about one-fifth of an inch of paint on the edges so that it runs over the cardboard.

Don’t worry too much about the paint getting stuck to your mask. It’s easy to remove it later, and it’ll leave you with a wonderful finished mask to show off to everyone! It’s also a good idea to wash away any excess paint once you’re done, so that you don’t wind up with smudges or smears on your dog.

Then it is time to glue the mask onto your dog’s head. First you need to make sure that you get a secure fit between the mask and your dog’s head. As soon as you’ve made sure that it’s secure, then you can begin to glue the mask on the dog’s face. Take the piece of cardboard that is used for the base of the mask and then fold it over. Make certain it’s quite powerful and then use your hands to secure the cardboard down in place.

Keep your hands out of the way and use tape to hold it in place as you repeat the process on the cardboard folds until you’ve got the mask snugged firmly onto the face of your dog. Don’t make the folds too large or else it could look messy. Once you’ve completed this, you can then take out the mask and then attach the cardboard ears. And attach the other area of the mask onto the dog. Make certain the ears are level and be certain it’s not too short or long as this can cause some problems with the mask slipping off the dog’s face.

If you are using a dog mask as your pet security, you’ll have to do some sanding to be certain it is safe on your dog. You can do this by sanding off any excess paper that may have been removed from your mask.

Leave a Reply